Intelligent marking machine launching

1.Machine introduction:

2．Machine Installation:

3．Wiring diagram：

4．Equipment use precautions and routine maintenance：

1. Pay attention to the use of the marking machine to ensure that the working

 Non-professionals are not allowed to turn on the machine. ring mirror is ventilated and the working environment is clean.

2. Before starting the equipment, ensure that the equipment casing is grounded well to avoid equipment failure or board burning.

3. Be safe, be careful not to get hurt, and don’t burn your hands under the laser when marking.

4. Use the test products before marking to ensure that the products are marked after correctness; when marking, you should carefully check them carefully and mark them again without any errors to ensure that they are safe.

5. Make sure that the marking machine is turned on and off normally, and you cannot suddenly power off and turn off the power directly.

6. Remove the laser head protection cover before turning on the marking machine, and when opening, do not place anything under the laser head to avoid the laser burnt when it is turned on.

7. After use, turn off the computer, turn off the marking machine, and cover the instrument.

8. The laser is an air-cooled laser that requires a working environment (room

which are strictly prohibited by non-manufacturers.

 temperature) at a temperature between 10 ° C and 35 ° C (25 ° C is optimal).

9. It is strictly forbidden to bend the fiber. If it needs to be bent, ensure that the minimum diameter of the fiber is greater than 20 cm.

personnel leave.

10. When an abnormality occurs, first turn off the laser power supply and the power supply, and then check.

5．Routine maintenance：

1. Regularly clean the surface and inside of the machine to ensure that the

interior is clean.

2. The field mirror with poor working environment is recommended to be the field mirror from the frame, bend the mirror paper into a few folds, wet with the cleaning solution, and use wetted Lens paper lightly rubs the surface of the lens several times until the mirror is clean and there is no dust or oil on the lens surface.